I am handling a situation where with DI 1 I have to monitor the watchdog signal generated by an electronic equipment.
Unfortunately, the signal is not continuous, but is a square wave at about 1 Hz.
The timing currently offered does not allow for this to be managed, as SMS messages are continuously sent separate from the minutes set.
It would be useful to have the option of setting an input timer, which would require stability at the logical condition required by the rule for <x> continuous seconds before switching the trigger.
This option would also be useful in all those situations where there is a signal that needs to stabilize, I am thinking, for example, of a float in a tank that is filling up or monitoring wind gusts with an open-contact anemometer, and it is not possible to use Network Monitor since there is no PC present.

Migrated from the SMSEagle UserReport forum (2024-02-17). Legacy status: Being considered.